220V 380V AC Power Lightning Protector ISO9001 Certificated

Protection in stages
The first level of protection
The purpose is to prevent the surge voltage directly from the LPZ0 zone conducted into the LPZ1 zone, tens of thousands to hundreds of thousands of volts of surge voltage limit to 2500-3000V.
Into the power transformer low-voltage side of the installation of power lightning protector as the first level of protection should be three-phase voltage switch type power lightning protector, the lightning flux should not be less than 60KA. the level of power lightning protector should be connected to the user power supply system inlet between each phase and the earth's high-capacity power lightning protector. Generally require the level of power lightning protector with a maximum impact capacity of 100KA or more per phase, the required limit voltage is less than 1500V, called CLASS I power lightning protector. These electromagnetic lightning protectors are designed to withstand high currents from lightning and induced lightning strikes and to attract high-energy surges that can divert large amounts of surge current to earth. They only provide limiting voltage (inrush current flow through the power supply lightning protector, the maximum voltage appearing on the line is called limiting voltage) for the medium level of protection, because CLASS I protectors are mainly absorbed by large surge currents, they alone can not fully protect the power supply system inside the sensitive power equipment.
The first level of power supply lightning protector can prevent 10/350μs, 100KA lightning wave, to the highest protection standards specified by IEC. Its technical reference is: lightning flux greater than or equal to 100KA (10/350μs); residual voltage value is not greater than 2.5KV; response time is less than or equal to 100ns.

Surge protective device, protect against lightning surge voltages in solar system (photovoltaic

power supply system).

These units must be installed in parallel on the dc networks to be protected and provide common

and different modes protection. Its installed location are recommended at both ends of the dc

power supply line (solar panel side and inverter/converter side), especially if the line routing is

external and long.

FAQ